Home
Teams
Profile
Connect
Constants
Units
Engentic
Location
Loading…

Compound Pulley Pulling Weight

In the setup below, determine the time required for the compound pulley in the figure below to reach a speed of 600rpm starting from rest.

Solution

Kinematics and Geometry

Assume A hangs from the outer radius and B is tied to the inner radius. When A falls, the pulley turns and pulls B up the 3:4 slope, so friction on B acts down the slope. Both ropes stay tight, so each block's acceleration equals the angular acceleration times its radius.

Equations of Motion

Write one equation of motion for each block and one for the pulley. Then multiply the block equations by their radii and add all three. This cancels the rope tensions and leaves one equation for α. The forces holding B back are its weight component along the slope plus friction.

Time to Reach 600 rpm

The angular acceleration is constant and the pulley starts from rest, so ω = αt.